CELEBRATING 130 YEARS NEW & SPECIALTY PRODUCTS PRODUCT LIST INTERACTIVE CATALOG CALCULATORS SUPPORT PRODUCT LITERATURE REQUEST INFO Ross Valve

Directions

Directions to Troy, NY:
From North - Take NYS Adirondack Northway I-87 South to Exit 6 - 7. Stay to the right for Exit 7, which becomes NY-7 East, then proceed 5.3 miles to Troy.

From South - Take NYS Thruway I-87 North to Exit 23 (I-787). Take I-787 North 8.8 miles to exit 9E (Troy / Rout 7 East).

From East - Take Mass. Turnpike / NYS Thruway I-90 West to Exit B1 (I-90 / Albany). Take I-90 17.7 miles to I-787 North, then continue 5.1 miles to exit 9E (Troy / Route 7 East).

From West - Take NYS Thruway I-90 East to Exit 24. After toll booth take center lane to NYS Adirondack Northway I-87 North, and proceed 5.9 miles to Exit 7 (NY-7 East). Stay to the center / left and proceed 5.3 miles to Troy.

Directions to Ross Technology Park (75 102nd St, Troy, NY 12180)
Follow directions to Troy, NY from above.
While on Route 7 East, turn right onto the ramp towards Downtown Troy. Stay Right on ramp towards Hutton St (US-4) and proceed to the second light (River Street). Turn right (North) onto US-4 (River Street) and go approximately 1.3 miles. Take a right onto 102nd Street and proceed all the way to the end. You will pass through the main gates as you enter the Ross Tech Park, and arrive at a stop sign. The Ross Valve Corporate Headquarters are on the first floor of the building immediately ahead. For Shipping & Receiving, proceed to the left and follow the road all the way around to the set of 5 loading docks (perpindicular to the main building.)

Directions to Oakwood Ave Plant (6 Oakwood Ave, Troy, NY 12180)
Follow directions to Troy, NY from above.
At bottom of the bridge (Collar City Bridge), stay in left lane, and go straight through light. Take a left at next light from inside lane(s) onto 10th Street/ SR-40 / Oakwood Ave. Go approximately 150 yards and turn right onto Archibald St (just past Ross Valve main entrance on right). Immediate parking is available on right or left (Note: The main entrance is located on Oakwood Ave.)

Years of experience have shown that our rigid red brass control piping (minimum 1/2 inch diameter) can stand up to the decades of service expected of our valves.A visual position indicator gives an accurate assessment of valve position, which is invaluable in monitoring valve performance and troubleshooting.Our standard strainer to protect the controls from contaminants is actually functional - with over 7 square inches of surface area.Due to the long stroke inherent to our piston style design, we can optimize each valve's performance by tailoring the seat contour design to the valve's specified application.Each valve is built standard with ANSI Class 250 construction with regard to wall thickness, internal components, and controls. Flanges are sized and drilled as specified to mate with adjacent pipes and equipment.All ferrous surfaces are coated with two layers of NSF Certified Epoxy Coating inside and out.The rugged bottom cylinder ensures that the valve piston is fully guided above and below the seat to counter any lateral forces and ensure correct alignment at the seat.All control devices are built to meet our strict requirements for durability, in order to ensure a long service life of the entire valve assembly.Though every valve is tested at the factory prior to shipment, devices like the speed control valve may be adjusted in the field for further refinement, should operating conditions change.The Ross Piston Style design utilizes rugged seals that wear gradually and are not vulnerable to sudden failure or rupturing.Ross Valve | Automatic Control Valves for the Water and Wastewater Industries